Sliding Bearing

1. It is made with marginal-EPB3M material wich is flexible for dimension viriation. Alternative material Marginal-EPB7 is also available for special wear resistance requirement.Thin-wall plastic

Features:1. Self-lubricated ,Maintenance free.2. Easy assembly 3. Groove design reserves the material expansion allowance 4. Double flanges designation5. Suitable for rotation and sliding motions6.

1. Low friction coefficient 2.Applicable for soft shaft3.Wear resistance material for working temperature lower than 80℃. The application is for the condition where the shaft hardness is not

1.Self-lubricated material with good elctricity conductivity. Mainly used with the high load and electricity conductive evironment2.Continuous operating temperature: -40℃/+140℃3.Specially use for

EPB Plastic Sliding Bearing1.Low friction.2.Very common; suitable for most of average and low load;3. Material: EPB engineering plastic 4.Light wear against different shaft materials;5. The most

MG-6T Tension Bushing:spring steel coiled bearing is made of spring steel plate as basematerial, and then ishardened by the whole,and the inner and outer surface is ground and processed.This product

Metal-polymer composite bearings; Bimetallic composite bearingsMetallic self lub.bearings; Plastic self-lub.bearings

Marginal Bearing is a professional corporation for the holistic solution of technologies on self- lubricating and pre-lubricated plain bearings. Marginal bearing locates at Jiashan, Zhejiang, where

◆ Introduction: MG-1B is with a high safty factory, which is particularly appropriate for high temperature environment where oil is unsucient and where the machine has to be under successive long

◆ Introduction: MG-1A is a composite material of PTFE compound tape on aluminum shell, the PTFE tape up to 0.20mm thickness enable the bearing can be sized after fixed, meanwhile the thick PTFE layer

◆ Introduction: This new material uses the PTFE fibre fabric overlay on steel backing, the fabric is with high load capacity and much longer operating life comparing with conventional 3-layer bushes.

◆ Structure MG-EPB series material is a thermal mould character plastic processed by crystal engineering plastic as basic material with proper intensifier and lubricant. The rigidity and high